Pursang's "Vintage Morgan" Inspired 3 Wheeler.

Original plan for driving the trike was with a rear mounted engine and a swing arm. (Simple)
In order to fit it into the available space, I was planning to extend the motor drive past the front of the wheel and put the Torque Converter on the other side of the wheel. This was not going to be a problem as one of my 'donor' engines is from a portable generator. These have a tapered drive into the alternator rotor, press the rotor apart and away we go, extended shaft, (Simple). Next step was a short swing-arm pivoting in-line with the output sprocket of the TC. (Simple... sketch attached). For proper alignment with the wheel sprocket, I would need to place the drive sprocket on the inside end of the TC. (Simple) Apparently, this is possible with a genuine Comet TC. My Chinese clone, TAV20, on the other hand, has a 5/8" shaft through the rear pulley and drive sprocket, expanding to 17mm through the alloy bearing support. (Not so simple??) New Plan in development.