-
Pursang's "Vintage Morgan" Inspired 3 Wheeler. reacted to this post about 1 week agoAfter cutting the key ways, it turned out that the shaft (bought new) was actually spaghetti.
Visibly plus or minus 1mm at several points along it's 1300mm length.
I set it up in needle roller bearings and V-blocks, then measured and massaged it to nearly straight.
Biggest variation is now 0.1mm (around 0.004".), hopefully this will be sufficient.
Post is under moderationStream item published successfully. Item will now be visible on your stream.
The Cyclekart Club of Australia acknowledges the Traditional Custodians of country and their connections to land, sea and community.
We pay respect to Elders past and present and extend that respect to all Aboriginal and Torres Strait Islander peoples today.
The Cyclekart Club of Australia Incorporated