Cyclekart Club of Australia Logo              
  •   Tomaled2563 reacted to this post about 2 years ago
    OK, so I made my first part! Well, kind of - it's a wooden mock-up of the pair of adapters I'll make for my $90 wheel/tyres to fit the 25mm rear axle I'll use. The mock-up shows that it works but that I'll have to countersink the bolts coming through from the back of the adapter and into the wheel hub. I chose this side (92PCD) of the wheel rather than the other side (100PCD) to attach to the adapter because the wheel hub is clearly stronger on this side. To be clear, I'll be changing the two existing 15x37x11 bearings in each rear wheel, and substituting four 25x37x7 bearings in each wheel (two each side), so the adapter does not carry any weight load, only the driving and braking load.
    Have fun!
    Simon
    Comments (1)
    • Looks like a nice solution. A lot easier to make than what I put together as it requires no welding.
      Reported
    Post is under moderation
    Stream item published successfully. Item will now be visible on your stream.
Unable to load tooltip content.

 

The Cyclekart Club of Australia acknowledges the Traditional Custodians of country and their connections to land, sea and community. 

We pay respect to Elders past and present and extend that respect to all Aboriginal and Torres Strait Islander peoples today.

 

The Cyclekart Club of Australia Incorporated