Cyclekart Club of Australia Logo              
   
Forum
Build Pages
Groups
Photos
Videos
Events
Resources
Marketplace
Filter
Show results from selected filters below:
|
Suggested keywords
x
Loading cover... Drag cover to reposition
Hugh

Hugh

  Registered Users Last seen online, 10 months ago
Cyclekartiste
Timeline
About
Forum Posts
Build Pages
Groups
Albums
Videos
Events
More    
  • Hugh
    Hugh started a new discussion, Just started
    Editing
    Just started
    •   General
    •   Saturday, 30 September 2023
    HI, I'm new to the group and live on the Sunshine Coast. I have just started on a project and have started on the chassis rails. I have got them cut to length and the taper at the front done, and next I want to drill the holes for the axles...
    HI, I'm new to the group and live on the Sunshine Coast. I have just started on a project and have started on the chassis rails. I have got them cut to length and the taper at the front done, and next I want to drill the holes for the axles before welding the cross members in. I was wondering how far from the rear should the axle hole center point be? From looking at plans on this site I would guess about 175mm or thereabouts. Would that be ok?

    Thanks
    More
    1. View Post
    0
    0
    0
    0
    0
    0
    Comments (0)
    Post is under moderation
    Stream item published successfully. Item will now be visible on your stream.
Unable to load tooltip content.

 

The Cyclekart Club of Australia acknowledges the Traditional Custodians of country and their connections to land, sea and community. 

We pay respect to Elders past and present and extend that respect to all Aboriginal and Torres Strait Islander peoples today.

 

The Cyclekart Club of Australia Incorporated